20 Most Recent
Jacuzzi Nova Whirlpool Tub H532 - Page 9 Questions & Answers
How to install whirlpool jacuzzi switch
Air Switch Repair
It sounds like you have a bad air switch located in your motor.
The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub.
This is a latching air switch and when you push the air button it latches to send power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off.
US Parts Center
6/6/2014 3:21:16 AM •
Jacuzzi Home
•
Answered
on Jun 06, 2014
When I push the start button motor running but not stay on
Air Switch Repair
It sounds like you have a bad air switch located in your motor.
The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub.
This is a latching air switch and when you push the air button it latches to send power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off.
US Parts Center
6/6/2014 3:14:23 AM •
Jacuzzi Home
•
Answered
on Jun 06, 2014
How to pull off the knobs
On most bath fixtures the knobs or handles are held on by a discreet screw set screw. If there is a plastic or rubber "button" in the center of the knob, gently pry it from the edges to remove it and there should be a machine screw going through the knob holding it to the valve stem. Remove the screw and the knob should come off. Sometimes requires some light tapping from the back side. If this doesn't appear to be the case, examine the back side of the knob to see if there is a set screw in a small hole going in sideways effectively clamping the knob to the stem. Often times this type will require a very small Allen wrench. Be sure to use the correct size or you will strip out the hex shaped opening and then will require drilling out. This is not what you want to be doing!
5/30/2014 1:18:49 PM •
Jacuzzi Home
•
Answered
on May 30, 2014
Jacuzzi tub will not turn on button will not click on as usual
Your problem is most likely NOT the air button but the switch in the motor.
Air Switch Repair
It sounds like you have a bad air switch located in your motor.
The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub.
This is a latching air switch and when you push the air button it latches to send power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off.
Rod
US Parts Center
4/13/2014 11:20:33 PM •
Jacuzzi Home
•
Answered
on Apr 13, 2014
Water level sensor
The 'low-water' sensor installed in a bathtub is designed to NOT allow the pump to run without water contacting it.
It sounds as if this is operating as it should.
Once the pump comes on you should be able to touch the "logo" or the on/off button to turn the pump on and off.
If the pump is not turning on/off when the tub is full of water you may be experiencing a problem with the control box under the tub skirt.
Rod
US Parts Center
888-521-6183
4/8/2014 5:35:52 PM •
Jacuzzi Home
•
Answered
on Apr 08, 2014
Not finding what you are looking for?