American Standard Evolution 2425V-LHO.020 White 5 Feet x - Answered Questions & Fixed issues

You need to install whatever will function best to get the skirt raised up to match.RodUS Parts Center888-521-6183

If your back jets do not turn on then there is a valve you need to adjust on the tub somewhere or they need to be turned on by the face of each jet by turning them counter clockwise.RodUS Parts Center888-521-6183

Have you considered your looking for a plumbing part
for a common name brand?

Go to a plumbing supply where the pros go

some people use spray foam which you can add later

No. but it will be noisier when running

hey bill no easy way what we do is measure height of edge that will sit on stud and tack stud in tub area and dry fit tub.when you do that you can see how much space is under tub for your mortor you should use light weight cement called structolite its white and not as heavy and yes a piece of tar or resin paper is a good idea

This could be caused by a faulty relay or switch in the control panel. It is best to have a qualified technician inspect the control panel and replace any faulty components. If the issue persists after replacing the faulty components, then it could be a wiring issue and a qualified electrician should be consulted.

To make the water level higher in the pan, the outlet pipe must be higher.

Adjust the float on the fill valve

Depends how old your toilet is, it may be a calcium build up problem on your little inlet pipe inside your tank, but first check your water shut off valve on left side of your toilet near the wall....It may not be open all the way OR the valve has an issue...

Hey, One thing is that maybe there might be some loose plastic shavings in the fill line. From the Factory? or maybe was inside the water line going to the toilet when you connected the line to toilet. Shut off the water and get some towels and something to catch the water and disconnect it from the toilet and use bowl or what ever to catch the water and slowly turn it on and see if anything comes out. Maybe if it is in the line inside the toilet it might fall out by lightly tapping on the fill line inside the toilet to help it fall out. Just a thought when you said it "Sings" that sounds like trash inside the line going to the filler tube and bowl, hey try it who knows it might work. Okay

Hi, First, carefully remove your tank lid, and place it where it won't break or fall. Look for a four-digit number located on the back of the tank, near the water level mark. This is your tank model number. If the number starts with a two, it is a one-piece toilet. Then....visit this link: https://www.americanstandard-us.com/parts-support/faqs/toilets Good Luck!

water level to low or drain partial clog

More likely the sensor has malfunctioned.

these are called phantom flushes. the water is slowly leaking around flapper or the is a scratch of the flapper seat. I use fluidmaster parts

Toilets wear out from mineral deposits. Fixn may cost more then new. Googl used commodes first

air bound or pump overheating

Water turned off or fill valve bad.

https://www.americanstandard-us.com/-/media/sites/asus/files/product-specs/bulk/specsheet5023100.pdf?la=en

I think it's not a wise decision to clean a toilet fill valve, rather than buy a new toilet fill valve and replace with the old one. Thanks.