Whirlpool Caresse 2 Person Bathtub Seats Two Adults - Answered Questions & Fixed issues

Go to Jacuzzi.com and plug in model and serial no. you should be able to find an operation manual there.

first of all you need to be draining the tub completely and removing any bath mats or items from inside. Fill the tub with hot water, ensuring that the jets are covered. You can use white vinegar, 2-3 cups of white vinegar directly to the water in the tub. Turn on the whirlpool system and run it for 15-20 minutes. While the jets are running, use a soft-bristled brush to scrub the jet openings and the interior walls of the tub. Drain the Tub: Refill the tub with clean water and run the jets again for another 10-15 minutes to rinse out any remaining cleaning solution. This should help. This is what I did with mine

Didn't I answer this yesterday? I said a local plumber, a spa pool shop, fill them with silicone if you aren't going to use the jets again, or just replace the tub if it is leaking. We don't charge for anything. We are Fixya, we only supply information, nothing else. Fixya isn't really the place to ask for quotations. General plumbers https://www.google.com/search?q=santa+fe+nm+plumbers or specialist plumbers for spa baths https://www.google.com/search?q=santa+fe+nm+spa+bath+plumber ..

One of these? https://www.amazon.ca/Bath-Drain-Foot-Lock-Plastic/dp/B00L66HVWM Can't you get a drain snake down the side, or these are very effective for pulling long hair blockages and are flexible enough to easily go around corners. I use mine every 6 months. The Green Gobbler cleaner is also very good, or use Draino Gel. https://www.amazon.ca/dp/B00IJFU440/ref=sspa_dk_detail_1?psc=1&pd_rd_i=B00IJFU440&pd_rd_w

Green Gobbler Dissolve Hair and Grease Clog Remover

Home Depot https://www.homedepot.ca > ... > Drain Cleaners Highly effective against grease, hair, soap, and fats. Green Gobbler Dissolve Drain Clog Remover is odourless, nonflammable, and safer to use than ... $18.98 ..

There is help and videos in this link https://www.google.com/search?q=aquaglass+tub.+replace+toggle+switch If it is completely enclosed, a plumber will normally make an inspection panel from the other side of the wall to gain access. https://www.google.com/search?q=aquaglass+tub+installer ..

every motor has a frame size and horsepower listed on it. search for a new one that way. i would think since its driving a pump it will need to be a totally enclosed/driproof model

Did you turn the outer rings on the jets? They could be turned off. They are used to adjust the bubble flow, but also to turn them on or off.

Search google

You have some bacteria build up on the inside of your tubing of the tub.Try some cleaning solutions per directions on the bottle of tub cleaner made specifically for this situation.Cleaning Solutions US Parts Center

I have galbocca jet tub which is no longer working. I live in Lawton, ok. No one works on them here. Any suggestions?

Check breaker and reset switch.

no power motor seized up thermal overload button needs pressing in

I would do it chemically with solution designed for the job. Or maybe just put vinegar in the water and let it circulate for a while and then replace the water.

Hi,
If you can hear the the motor running then call the plumber....if the motor don't run then call the electrician...

Or find someone like me that does it all...:-)

heatman101

Might not be the button, they use air pressure to travel through a tube to a remote switch near the motor. You have to get under it to see if the tubing is loose or cracked.

Hi Virginia, I've done some research on tubs with jets, and from what I've read I wouldn't put anything granular in the water. The granules may damage your pump and also when the water stops some granules will be left in the pipes, where they will decompose and turn into.... well, I don't think it'll be nice.

try a plumbers shop as it is a whirlpool tub you state that it is a whirlpool tub then you say don't know what brand of tub it is whirlpool is a brand name any way the plumbers display of bathroom units and tubs will help you as the jets used are generic and not specific for the tub

Manuals and Troubleshooting Whirlpool whirlpool double door wiring Google Search

Have you tried the button on the top ledge?

It is biofilm growing inside your plumbing. The black flakes are most likely biofilm. Check out specific cleaners designed to remove that crud. The best is called OH YUK