Kohler 30RESA 30kW Standby Generator Beige, Standby - Page 3 - Answered Questions & Fixed issues

https://www.dieselgeneratortech.com/diesel-generators/faults-caused-by-low-load-operation-of-diesel-generator.html

http://www.kohlerpower.com/onlinecatalog/pdf/g2058.pdf Safety shutdowns:

1. Loss of coolant
2. High water temperature
3. Low oil pressure

Likely one of these. If no indicators at a panel check at the connector.

http://www.kohlerpower.com/home/home-generators/products?prodNum=12RES Website shows 5 yr 2000 hrs. <?>.

There might be two reasons for the failure of generator auto start. 1. It is the ATS automatic conversion control device that does not issue the start generator command after the mains power failure or phase loss operation, or the self-starting relay failure, which causes the generator to not start itself. This situation is relatively rare. 2. It is the generator start battery failure, and this kind of situation is relatively more.

https://www.kohlerpower.com/home/common/pdf/tp6804.pdf

get it from a Kohler service agent spares

maybe this what you wanted you , Service Kit Kohler Marine Generator Models 4EF 5E 6EF 7.3E Maintenance Service Kit Kohler Marine Generator Models 4EF 5E 6EF 7 3E

You need to repair your locked rotor then it will work

try typing in google might come up with help

Look on line. There are whole bunch information there. Good luck Mai

drain the fuel and replace with ethanol free gas

The Kohler 7.5 R had a possible three different voltage regulators that could be used. You need to check there first. Also if you can get it the service manual for these are tp-5110 Which will show you how to test the regulator o the bench. There was a 5 6 and 7 pin regulator that could have been used.

check diodes on main control board. they short out if something went wrong.

If you want to solve your problem, click on the link I attach Best Manuals

usually means you have to replace the carb and get the gasket with it. when the needle valve develops a problem they don't intend for you to fix it. this has been my experience.

Check your owner's manual

If your mower runs fine, but dies when the blades are engaged, that has nothing at all to do with the starter - or with the engine. There is a malfunction is in either the electrical system, PTO clutch or one of the safety features somewhere. Check all of the belts first for wear or breakage, then if they're OK, you probably need a small engine mechanic, but it doesn't sound really serious.

the remote has separate starting system check the unit it could be the magnetic switch. manual start bypasses this

first I would check is the low oil sensor circuit they can fail or they work best when the oil is low

Does this machine have a fuel filter if so make sure it's clean. Does it have a fuel bowl? Take it off and clean it out real good . also clean the fuel jet. These are why the engines do not start or run properly if one of these are dirty. Dirt keeps the fuel out of the carb.