20 Most Recent
Whirlpool 2 Person Corner Air Tub By Vitabath Bathtubs - Page 4 Questions & Answers
I have a Mirolin whirpool for 2 years now .
Mirolin warranty is horrible. Immediately after install the tub leaked because of a defect in the tub's drain hole. Mirolin won't cover any damages caused. Had to pull our whole ceiling below and replace flooring.
Get jets unplugged
Cleaning your Tub
There are several options for cleaning the piping on a jetted bathtub.
The reason you have a residue on the bathtub surface when you are done bathing is because there is bacteria built up in the plumbing of the jetted tub. In order to remove that and reduce the amount of "yucky stuff" coming into the tub when using it, we recommend a regular usage of a jet cleaning product about once every couple of months
Here is a link to the cleaning products I can find right now. There may be other out there that I am not aware of but I do know these products work well in all jetted bathtubs.
US Parts Center
MY WHER25 REV. OS. IS LEAKING AT THE HOLE IN THE
Remove the faucet spout and unscrew the screw keeping the white plastic piece on the bottom (of the faucet). It's where the red and black tubes enter. Pull out the white plastic with the tubes and clear it of debris (usually placed there when your disposal backs up the black tube, which serves as the filter's drain tube). Once it is cleared of debris, make sure the black rubber washer is back in place (it may be stuck in the faucet, so look for it) and replace the plastic, screw the screw back in, and secure the faucet again. I had this same problem and doing this solved it. Should take about 5 minutes or so. Good luck.
Helena hw4272 by hessco
Not sure where you are from but I have a Helena that we are replacing that has a good pump and motor. You may be interested in it even for parts.
I own the Wher25 Reverse Osmosis system. I
There is a blue cap on the body of the white pressurized water tank. Twisting off the blue cap, you will see a air nozzle - similar as those on the tire. You need to pressurized the tank to 60 PSI. I spend hours to figure out this solution on my own system.
11/15/2013 7:52:57 AM •
Home
•
Answered
on Nov 15, 2013
My washing machine will not
most likely there is a switch that is burned out. on the lid there is a peg and that peg goes down in the hole and triggers the switch to let the machine know the lid is closed. romove the front panel (should just pull off) this will expose screws to remove top. switch will probably have burn marks on it. replace it.
Not finding what you are looking for?