American Standard 2770.018w.020 Cadet Whirlpool White - Page 7 - Answered Questions & Fixed issues
My american standard jacuzzi tub
check the air tubing coming off the back of the motor. that tubing should connect from the air switch on the motor to the bottom of the air button on the top of your tub.
if it is not connected then it will never turn on.
2/20/2011 2:01:24 PM •
American...
•
Answered
on Feb 20, 2011
•
737 views
Jet tub pump is not working
It should be wired on a GFI receptacle or a breaker in your panel box. Check both of these before taking out your pump.
2/2/2011 6:49:28 PM •
American...
•
Answered
on Feb 02, 2011
•
85 views
My american standard low flush toilets are
Please contact our American Standard Customer Service Department -1-800-442-1902. One of our customer service representatives will be available to help you solve the problem
1/27/2011 4:57:39 PM •
American...
•
Answered
on Jan 27, 2011
•
223 views
The toilet takes a long
Is the flapper valve slow to return to the closed postion allowing water to flow through the flush valve? Make sure the toilet flapper is moving freely and is sealing properly against the flush valve. If there is no lengthy or continual water flow in to the toilet bowl then this is not the problem.
Is the water valve on the water fill line to the toilet tank fully open? This may seem silly but it could be this simple.
Check to make sure your fill valve is opening fully. If you have an older toilet there may be some deposits that need to be cleaned way to allow free movement.
If toilet does eventually fill to the desired level, there is no leakage, water valve on fill line is fully open and fill valve is opening fully then recommend you shut off water supply, drain toilet and disconnect water fill line from the water valuve and toilet tanke to make sure there is not a blockage. If the water line and connections are clear you may need to remove the fill pipe in the tank and check for blockage. If this is very old, conisdering the cost and effort, it may be simpler to replace at this time rather than trying to extend the life.
1/26/2011 4:54:28 AM •
American...
•
Answered
on Jan 26, 2011
•
639 views
To change my bathroom sink faucet I first tried to
These shut-off valves don't last long before they lock up. There is always the chance that they'll break. Go ahead and turn off the main water valve, then remove the packing nut (Google images for valve packing nut). This should allow you to turn the valve stem. However, you still run the risk of not being able to get to shut off. I almost always have to replace these shut-off valves whenever replacing a faucet anyway. So, assuming the valves are threaded on to the supply pipe (not soldered) then buy replacement valves as a very first step. I am assuming you won't want to do the soldered fitting yourself.
Good luck,
1/18/2011 9:02:29 PM •
American...
•
Answered
on Jan 18, 2011
•
192 views
My newly installed tub pops
not sure what an 'oil can' sound is... but ... if it is popping and creaking when you step into the shower then the base is not properly supported. there is a a gap or two between your floor and the base of the shower floor.
1/13/2011 2:46:33 PM •
American...
•
Answered
on Jan 13, 2011
•
137 views
Not finding what you are looking for?