American Standard 2770.018w.020 Cadet Whirlpool White - Answered Questions & Fixed issues


if you have a captive air expansion tank its most likely bad and leaking inside. means the rubber bladder leaked internally. cheap money and easy to replace. do not even try to test the air pressure in an old one. or try to refill it. replace it. good luck

American... | Answered on Jul 02, 2017 | 96 views


The cheapest one I've found so far was $200. You just need to search differently, try these: http://www.google.com/search?en&q=PUWWSCAS12598R&ie=UTF-8&oe=UTF-8 or http://www.google.com/search?en&q=puwwas1298p&ie=UTF-8&oe=UTF-8

American... | Answered on Aug 26, 2011 | 753 views


if you can get to where the motor is..there should be a small plastic hose the inserts into motor...or plug...if you pull the hose off it should allow button to push out again

American... | Answered on Jan 03, 2011 | 387 views


You need access from the back of the jet. What you do is cut out the old one and install a new one. I suggest that you use a marine grade, under the waterline sealer. Silicone will not work. The under the waterline sealers take several days to cure, but they work. The hoses get glued with a PVC type of sealer that you get from a hot tum place, along with the jets needed.

American... | Answered on Dec 06, 2010 | 327 views


Go to a hot tub company, they have scale type cleaners that do this job. It does require draining a few times, but it is worth it.

American... | Answered on Sep 18, 2010 | 412 views


The pump is usually at the side/rear of the tub, opposite the drain, the faucets can be mounted anywhere, but usually over the drain. The panel could be tiled, and just grouted in, if it is not exposed, try tapping on it to see if it sounds different in spots. Who knows, it might just fall out. How about behind the back wall?? Closet? Access? There is no electrical parts in there to repair, Pretty sure it is just the motor. and a bunch of pipes glued together and stuck through the tub. Did you fill the tub with water before trying the jets? Just checking. Hope this helps.

American... | Answered on May 27, 2010 | 303 views


i am assuming this is a jacuzzi make sure the air ports are not clogged it has to **** air to be able to make bubbles

American... | Answered on May 10, 2010 | 132 views


i've been on board during many of these initial start-ups, there is a little red re-set switch on the motor somewhere (you'll see it), it is usually tripped, just push it back in, you'll usually hear it click when you push it in .

American... | Answered on Jan 03, 2010 | 180 views


Remove access panel make sure pump is plugged in some electricians put a GFI outlet under tub for motor make sure GFI did not trip. Next the switch is an air switch look for the hose going to switch is connected last you may need a new air switch which is common to fail

American... | Answered on Nov 15, 2009 | 726 views


Jet tools only remove the wall fittings from the jet body. Most bathtub jets are removed by turning them counter clockwise.

American... | Answered on Nov 15, 2009 | 982 views


The bearings (or bushings) of the pump or pump motor have siezed, these can be replaced on some models but for the most part you will need to replace the pump and/or pump motor. and as where to get parts, i would suggest the outlet from wich you purchased the unit or another appliance outlet. Or if you feel up to the challenge, im sure you could find replacement parts on the internet: google, ebay, etc.

American... | Answered on Sep 10, 2012 | 1,748 views


Most of these jets turn to close. Check if you turn the nozzle. Hope it helps

American... | Answered on Jun 16, 2009 | 771 views


no manual. Sounds like the motor is no good. What model and brand of pump do you have?
replacement Bath Pumps

American... | Answered on Apr 18, 2009 | 1,248 views


Well there are two things....You say "buzzes?" Like pump is running "humming" & not pushing water. That would be an "airlock" in the pump & it needs to be primed.
If it's "buzzing" & pump motor is not turning (Like it's froze) you might have a bad start up capacitor on the pump that needs to be replaced. Worst case scenerio entire pump needs replacement.

American... | Answered on Mar 27, 2009 | 889 views


sometimes theres caps on top pop the cap and tighten the screws and sometimes there are nut or wing nuts on the bottom...simple enough for you?

American... | Answered on Sep 06, 2019 | 40 views


Depends how old your toilet is, it may be a calcium build up problem on your little inlet pipe inside your tank, but first check your water shut off valve on left side of your toilet near the wall....It may not be open all the way OR the valve has an issue...

American... | Answered on Jul 12, 2019 | 46 views


Hey, One thing is that maybe there might be some loose plastic shavings in the fill line. From the Factory? or maybe was inside the water line going to the toilet when you connected the line to toilet. Shut off the water and get some towels and something to catch the water and disconnect it from the toilet and use bowl or what ever to catch the water and slowly turn it on and see if anything comes out. Maybe if it is in the line inside the toilet it might fall out by lightly tapping on the fill line inside the toilet to help it fall out. Just a thought when you said it "Sings" that sounds like trash inside the line going to the filler tube and bowl, hey try it who knows it might work. Okay

American... | Answered on Jul 12, 2019 | 77 views


Hi,

First, carefully remove your tank lid, and place it where it won't break or fall. Look for a four-digit number located on the back of the tank, near the water level mark. This is your tank model number. If the number starts with a two, it is a one-piece toilet.

Then....visit this link:
https://www.americanstandard-us.com/parts-support/faqs/toilets

Good Luck!

American... | Answered on May 06, 2019 | 56 views

Not finding what you are looking for?
American Standard 2770.018w.020 Cadet Whirlpool White Logo

Popular Tags

30 questions posted

Ask a Question

Usually answered in minutes!

Top American Standard Home Experts

US Parts Center
US Parts Center

Level 3 Expert

719 Answers

Donni Steen

Level 3 Expert

687 Answers

Mike

Level 3 Expert

4363 Answers

Are you an American Standard Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...