Rheem Paloma PTG-74PVN / RTG-74PVN Natural Gas Indoor - Answered Questions & Fixed issues
I only have a 1/2
Ask the local council what the incoming water pressure is you may be able to get a water reg on the incoming line to boost pressure .
6/11/2017 2:48:34 PM •
Rheem Paloma...
•
Answered
on Jun 11, 2017
•
83 views
How do I bleed the gas line???
Sometimes this can be done by turning the ignition key a few times, not all the way to start, just off and to the on position before engaging a start, you will here a noise for a second that's the fuel pump sending fuel to start car, so after a few clicks it builds up the fuel pressure, air is bled out naturally. ... hope this helps ?
2/24/2015 3:37:17 AM •
Rheem Paloma...
•
Answered
on Feb 24, 2015
•
95 views
Non return isolating valve dripping water tinuously
you have trash in the valve .shut it down take the valve apart clean it . also maintenance on this unit is needed.seal can be bad also. hope it helps.send pictures of the unit and age and model serial number.
4/6/2014 11:36:17 PM •
Rheem Paloma...
•
Answered
on Apr 06, 2014
•
93 views
Thermostat Pilot does not light
This unit should be electronic ignition. Multiple issues could be the cause. First check the flame sensor. If those is not the problem then probably a bad control board. Don't know specs on the resistance of the flame sensor. You could try cleaning it with an emery cloth or sandpaper. Do not touch flame sensor with fingers it will ruin it
1/15/2014 2:59:14 AM •
Rheem Paloma...
•
Answered
on Jan 15, 2014
•
69 views
Not finding what you are looking for?