20 Most Recent Tag Heuer Aquaracer Quartz Chronograph CAF1112.BA0803 - Page 9 Questions & Answers

same problem, anyone know?

mcdevito75 here, I hope you have a warrantee on your Tag Heur watch, if so, contact Tag Heur, if not, your on your own, (Sorry) sounds as though it"s lost some of it"s waterproofing ability or the seal around the crystal, usually a crystal sealer. Best Bet look for a small watch repair shop in your area, have them take a look at your watch. The Fog on the crystal is the tempersture change of the air in your watch, no watch is air proof, re-sealing the crystal should help, also, replaceing the rubber seal on the back of the watch.

Hi


Thanks for using FixYa. Please check these links for its manual:

Tag Heuer WK111A Manual

Tag Heuer WK111A Manual-2



Please do accept the solution if the issue is resolved or post a comment for further assistance.


Thanks
Rylee

Yes, there are special spring under the bezel, not the bearings. Bezels are stuck/not clicking because they are broke/worn out or very dirty. I would not advise to take off bezels, unless you have replacement springs and proper tools to fit the bezels back on watch. You can find bezel springs on Ebay, or visit your closest watch repair shop and ask them to order springs for you. Rate me, plz.

You can by it on Ebay. Follow this link and see the tool for yourself: http://cgi.ebay.co.uk/WATCH-REPAIR-TOOL-SCREW-WRENCH-FOR-WATCH-CASE-OPENING_W0QQitemZ300409380798QQcmdZViewItemQQptZUK_Jewellery_Watches_WatchAccessories_SpareParts_SM?hash=item45f1cb5fbe#ht_4475wt_954 Rate me, plz.

This is END OF BATTERY LIFE warning. Replace the battery and everything will be fine. Rate me plz.

RECOMENDATION:
Seek professional help.

GOTO
http://www.watch-clock-makers.org/


If you act now and are willing to take a chance see if you can remove the back off the watch and with a hair dryer warm it up just until its hard to handle and let it cool off a few times.


Hope this tip helps.
r/ David

Unscrew the crown and pull out gentle until it clicks outwards twice as if you were going to reset the time and then push it back in and try shaking gently to start the second hand

Unfortunately it is not possible to make any estimates over the internet. As the warranty for the watch already expired years ago, there is no reason to find any particular Tag Heuer dealer. You can visit your nearest watch repair shop and ask for an estimate.

If it's just a fogged crystal, you don't have to remove the works. Just remove the back and let it sit in a dry (Low humidity) room for a day. Removing the stem is something that should be left to the watchmakers. A fogged lens is from swimming or taking a shower while wearing it when the seals are no longer in perfect condition. Just being in a very humid environment can also fog a lens. Find a "Watchmaker" in your area. They will be better equipped to work on watches, than a jeweler.

This is warning: it's time to change the battery. Your watch is fitted with EOL (end of life) feature and this is how the low battery power is displayed. However, the watch will keep running correctly for about two weeks.

Rate me, please.

ETA or F0 movements are usually tags number 1 choice of movements.


ETA G10.711

Hi

I hate to be blunt be if it stops after 8 hours of wear, it may need a service! Most watches (particularly automatics which winds constitantly, when being worn).

Take it to your local watchmaker for a assessment? If it's less then 2 years old take it back to your place of purchase with reciepts as most swatch group (rado, longines, and tag etc) have a 2 year international g/t (that what we have here in australia and way, please consult your warranty card for verification!)

Unscrew the crown and press the lower button, this should advance the minute counting hand one press ata time. Pull ot the crown a further stop to advance the seconds hand and again to advance the tenths counter.