Razor E300 Scooter "motor problems" Questions

...motor, but if you check it with a volt meter, you will see what I am talking about. Good luck. hi ! i have the same problems ,only works on high gear ...i called little tikes they told me it can't be ...

...wont start i just bought the t-maxx 3.3. when i put in the ez starter evrythings works, the starter motor and the 3.3 motor runs. but the fuel wont ignite. i have tryed this on 2 battery lives (ez ...

need electric motor for dual control air pump I have a Halcyon AirPedic Sleep System (queen air bed) by Simmons, the Electric motor in the pump box went out. I want to replace just the motor Model # ...

mouth does not move Motor operating mouth assembly is bad. The process to remove it is tedious and the motor is specific to the design. This was a common problem with all of the motors in this series.

i had just bought a 30 ft sea ray with 2 350 motors 260 hp. one motor is smoking a lot from the inside of the motor but not to the out side, what would cause this problem. check oil level first,and ...

...spinning on the ground, it won't lift and fly, how do I fix it? Hi, There is a problem on the motor gear, check the underside where you could see a big gear that should spin when you try to

...rotor. the upper rotor operates. the lower rotor does not, I had the bottom apart the lower rotor motor is not turning while the upper rotor motor is turning if it has two motors. I do not know.

...the difs lock and it turns. but wont drive. i didnt know if it was my controller because the last motor i had smoked and threw sparks when it stoped working this one never did so i wasnt sure if it ...

I installed a new battery that is working fine but the motor has no power dwhen you sit on it. /what could be the problem? If you put in a new battery that has been fully conditioned and charged, then

i have a xl-5, a exposed negative wire keeps wrecking motors i have a xl-5 and it has a exposed negative wire from the batt to the esc and it has come into contact with the heatsink. could this be ...