clutch in the following sequence: Assemble the hub and secure the springs. You want to adjust the hub screw first. Gently turn the screw in until it contacts the ball, then back out the screw 1/4 turn
...clutch lever assembly (where the cable attaches to the gearbox) has gotten out of position on the Axle push lever (the shaft that goes into the side cover and the lever is attached to). The shaft is ...
clutch cable by undoing the adjustment nuts on the engine side of the cable and unhooking from the lever. Remove the nut on the gearshift pedal and pull of the pedal. Remove the dipstick. Undo all the
Question about Yamaha V Star Classic Motorcycles
...clutch cable. Slide the bellows up and break the locknut loose. Shorten the cable as much as possible. Remove the derby cover from the left side of the primary cover. In the center of the clutch ...
...clutch cable enters into), by unscrewing the 1/4" allen screws.4. Next remove the trap door which is fastened with screws, and located between the trans end cover you just removed and the trans main ...
Question about Yamaha V Star Classic Motorcycles
clutch assemble forward just enough to get the jackshaft out of the hole. If the jackshaft coupler come out with the jackshaft mark which end goes in what direction. There is a snap ring on the inside
...clutch cable or is it hydraulic? You must have some free play, if you do not this could be the cause off slipping in 5th gear. Also if all the plates look good , not flaked or burnt, the proper ...
...clutch assembly out far enough to get the jack shaft out. The ?connector? will probably come out with it. Make sure you mark it as to which way it goes back in. The chamfered end goes in towards the ...
...clutch cable as the arm was hit badly in a accident please The clutch release arm is knirled and attached to the shift release shaft that is extending into the case cover. There should be a 3/8 or ...
Question about Yamaha V Star Classic Motorcycles
clutch assembly etc. and the primary case etc using new gaskets as required etc., refill the primary with oil, reconnect the negative battery cable and check to be sure you have not forgotten anything
184 questions posted
Usually answered in minutes!
134 Questions
90 Questions
69 Questions
61 Questions
56 Questions