2004 Yamaha YZ 125 "put kick start" Questions

...any ideas what it might be???? MAKE SURE YOU HAVE SPARK AT THE PLUG MAKE SURE YOU HAVE COMPRESSION REMOVE PLUG PUT FINGER OVER HOLE AND KICK IF YOU HAVE BOTH OF THOSE TRY CLEANING THE JETS IN THE ...

put the plug wire back on the plug and lay the electrode end of the plug (spark end) up against the cylinder head with the end of the plug touching metal and kick the kick starter over. You should see

...kick axle with the holes in the back of the transmision then be sure to push on the gear to see if it popps into place. then bring the spring clockwise to fit into the hole. Besure the spring is ...

...kick start is jammed Were you riding it when it jammed because that could mean the that something is sized inside the motor, like the crank or the pistion it is the clutch side casing take it off and ...

...kick start and has alot of compression as i put a new wiesco racing piston kit in but this problem was prior to that all thats been set at the factory--only thing can ajust is idle speed--the ...

...kick start gear. Is it "locked up" in the clutch hub? Remove the clutch hub. Will the crankshaft turn freely now? Put the bike on blocks and turn the rear wheel. Will it turn? While the wheel is ...

...put plug back in plug cap and rest on head, must make a circuit, metal to metal kick over, need to see big fat blue spark, not wishy washy little yellow spark, and definitely wrong if no spark. don't ...

...kick it over a few times then put the plug back in it starts and runs for a few minutes then dies and wont start then i have to repeat my process. try a new plug......have you put to much oil in the ...

...put the spark plug back and kick start it it will start but to just give it a quick start with out doing that it wont start in my experience you have to get a new spark plug i just went through ...

...kick start has ceased and wont move and when put into gear the back wheel does not move. took cylinder head off to check piston and the piston moves fine. after it started for 10 minutes then died ...