My gas tank collapses in the center when riding. It will even collapse if it's even touched just slightly. I did notice that my fuel level is low when it does it. why is it collapsing? This is a V ...
Question about Yamaha V Star Classic Motorcycles
my 02 yamaha vstar 650 is very hard to start on cold mornings. ihave tried all kinds of things. i have to idle it up than idle it down than it will start. the chock does no good . Sounds like your ...
Question about Yamaha V Star Classic Motorcycles
I have a '77 Suzuki GS750. Was running ok. removed airfilter assembly and it wouldn't start, turns over, but only an occasional backfire. returned airfilter to original, ensured pcv hose and vacuum ...
won t start I'm not getting fuel out of my fuel ine to carb I changed the pitcock and still no fuel.and I seem to have vacuum going to pitcock Try switching to RESERVE, as it should be mechanically ...
bought a 1996 535 virago and it wants to flood out it cranked and ran fine then it wouldn't start and we changed the plug it cranked and ran then it started to flood what should we try Some Viragos ...
vacuum hose goes i contacted you a little bit ago about fuel lines and vacuum hoses, i believe the 4 vacuum hoses on the 4 necks going inbetween the carbs and head,i believe the 1,3,4 are plugged off ...
Question about Yamaha V Star Classic Motorcycles
i have a kawasaki zr 750 h1, i start it up fine but 10 mins down the road she splutters and stalls ( yes she does have petrol!) any ideas on what could be wrong? Sounds like a malfunction vacuum ...
carb adjustment poor mileage 2 things. A carburetor can be adjusted if you have any vacuum ports on the engine. With the engine running, use a Vacuum gauge and adjust the air mix to the highest vacuum
Question about Yamaha V Star Classic Motorcycles
my 98 Valkyrie sputtters and backfires at idle only runs fine down the road can you advise? sounds like the slow speed jets are clogged up Slow speed jets or vacuum leak. Check the vacuum lines at the
no pressure in suzuki sv1000s rear brakes. tried bleeding, cant get any pressure If the linkage from the brake pedal to the master cylinder is okay, there would be only two reasons you have no ...
136 questions posted
Usually answered in minutes!
177 Questions
90 Questions
69 Questions
61 Questions
56 Questions