...the starter motor that engages with the stater ring. Remove Starter motor, check the spring on the dog ( the shaft that comes out of the starter motor) its a faff to repair best replace starter ...
Question about Yamaha V Star 1100 Classic Motorcycles
...starter motor. the lights are full and bright Hi and welcome to FixYa, If the starter motor will not turn, a few ideas to consider: the starter motor is actually switched by the starter relay. The ...
Question about Yamaha V Star 1100 Classic Motorcycles
...starter motor is OK - but - the starter bendix (drive) might be cooked. The bendix is a clutch that is built onto the output gear of the starter that prevents the starter motor from being over-spun ...
Question about Yamaha V Star 1100 Classic Motorcycles
...starter motor spins. It is designed to let go of the gear once the motor fires up. If the mating surface of the one way clutch and the starter gear becomes rough or chattered, it will no longer grab ...
Question about Yamaha V Star 1100 Classic Motorcycles
...starter motor to the flywheel is chattered or damaged and needs to be replaced. The starter motor turns a small gear that is connected to a large gear by a small chain. On the side of the big gear is ...
...starter motor spins. It is designed to let go of the gear once the motor fires up. If the mating surface of the one way clutch and the starter gear becomes rough or chattered, it will no longer grab ...
Question about Yamaha V Star 1100 Classic Motorcycles
...starter motor is located on the front of the engine. follow the heavy starter cable wire to it. This model has a common starter clutch failure that should only be attempted by someone with much ...
Question about Yamaha V Star 1100 Classic Motorcycles
...still turn? I've seen cases where at around 15k to 20k the starter motor clutch goes out. Starter turns, transmission gears will still turn. But starter obviously not engaging the motor. Good ...
...starter...does not torn motor over That will be the starter clutch worn, it works on a roller bearing principal, after use on older bikes the clutch becomes worn and the bearings fail to return when ...
...could also be too low to energize the starter motor. Could also be a battery or alternator issue. Check the battery voltage and for any sounds coming from the bike when you push the start
484 questions posted
Usually answered in minutes!
188 Questions
192 Questions
110 Questions
106 Questions
77 Questions
