2004 Suzuki RM-Z 250 "timing" Questions

could you guys illustrate to us the correct timings for the camshaft of kxf25o dirt bike? We can't seem to fire up the bike hope to hear from you we are eager to fire up the bike. Thanks Set your ...

2005 Rmz250 wont start when hot. The bike starts with two or three kicks when its cold and runs great, but if you stall or shut it off. it will not start back up 90% of the time. I've had to catch it ...

I have a 2004 Rm-z 250, it has idleing issues. It idles fast at start up and you need to crack the throttle a couple of times to get it to idle down. this goes on all the time. is it a pilot issue? ...

2004 rmz250 wont kick start will usually compression start also runs hot Sounds like the timing may be advance too far or the carb could be needing adj. But since its running hot first check with the ...

whats the flat rate time on a 09 rm-z 250 transmission r&r? you may expect no lower than 10 hours because you have to remove motor and dissasembled and you may expect to reshim a valve or two that

Have problems cold starting 2011 suzuki rmz 250 used only 14 hrs. I noticed that when it finally starts rpms are very low for abt 3 seconds then resumes normal idle. Some times shuts off at low rpm. ...

I have an 04 RMZ 250 I just re-shimmed the valves and put a new piston in and bike was running great started first kick road it all over the street and golf course. went on ONE ride in the heat and ...

...you're kickstart pedal or hurt you badly..) i sugest you recheck valve clearance and make sure the timing is done when you are at top death center and you're exhaust cam is about to be open shortly ...

08 suzuki rmz 250 backfires i have checked the valve clearence and they check out fine. what else do i need to run through to fix the problem? timing and fuel/air mix

gear shift drops out of gear then some times willnot come out of gear A bent shift fork is the problem.