2004 Suzuki RM-Z 250 "motorcycle chain turns gear wheel" Questions

...gear then try a jump start but with the key turned off. If the rear wheel locks up when you jump on and release the clutch then the piston has probably seized up OR the kick start-to-clutch hub ...

...chain off, if the wheel is still stuck, it could be wheel bearings, If it turns freely, I would say your transmission or primary gears have locked up.. Also, check and make sure the rear brake has ...

...gear grinding noise was deafening and chain seams to kick. now ordered new chain and sprockets , but is there something else what it could be. thanks alan No.That was the problem.The chain and the ...

...gear... and the bottom of the chain kicked and oscillated a little bit too much.. approx 2-3 cm. Now if I raise the throttle slowly the chain does not kick, but on releasing it it does so again. This ...

...its the chain &/or sprockets)Broken tooth on a gear in the gearbox. I hope not as again a more difficult & expensive repair.Hope this helps you narrow down your problem Regards Andrew ...

...gear for chain on motor sprocket.Replace it if worn to that point. Hi,it dose sound like the front sproket has got worn teeth,but by tacking the wheel back to take up the slack when the sproket is ...

chain is slipping on the sprocket sometimes when in gear with the clutch pulled the back wheel is still turning when in gear sometimes it does not want to go into neutral as you see it is not all ways

chain about 1-1.5 inch play in the bottom middle, (between wheel sprocket and output sprocket-on the gear box). Do this is small increments, 1/2 turn at a time, then measure. Re-tighten the main bolt,

...chain has not broken your one way clutch inside the motor is slipping. On the back side flywheel is a one way clutch that grabs the starter gear when the starter motor spins. It is designed to let go ...

...chain ok .engin dont turn .in back off the motor noise chaine turn in empty... If your starter motor is running and the engine is not turning over, then the problem is in the one way clutch attached ...