...side of the bike it will spin counter clockwise (ccw) when the cycle is moving forward. If the drive shaft is on the left side of the bike it will spin clockwise (cw) when the bike is moving
...cycle in gear and the drive shaft spins, but the motorcycle does not move, you probably have stripped worm gears in the final drive housing. Take off the large fill cap on the side of the final drive ...
...drive down the road thrity seconds for it to die again. This cycle could go on forever, starting- driving- dying??? Have any ideas what to check out first? Thank - you sounds like a fuel problem, ...
my 1983 honda vt500c has GAS in the oil not water just gas any ideals as to what the problem could be? bike will still run. I would add the following thoughts for consideration. Many things can cause ...
Question about Suzuki RM 250 Motorcycles
...are even stocking cycle filters.... good kuck and safe riding On the oil cap for my 01 Suzuki intruder vs800 it says it requires 10 W 40 SAE. The differential fluid on the drive shaft is 75 90
...cycle in gear and see if the rear wheel turns. Is there grinding in the final drive? check final drive oil for metal chips. Pull the rubber boot back from the motor to the swing arm to check if the ...
Question about TGB Motorcycles
...cycle does not move then you should be looking at these conditions Drive belt worn out or deformation Ramp plate of movable drive face damaged Driving pulley spring broken Clutch weights broken Drive ...
Am I going to have trouble with the Stator if I put 55 w driving lights on my 85 Aspencade If you operate the driving lights only while at speeds and not idling for extended periods of time there ...
236 questions posted
Usually answered in minutes!
32 Questions
28 Questions
0 Questions
2 Questions