spec and cleand everything very thurowly and fule still flows right out of the back of all 4 carbs. Any suggestions? Float valve seats have o ring seals on some carbs, check those. Float level must be
i need the specs for setting the floats and jets on a 1986 kawasaki gpz 1000 The float setting is 17mm frombase of carb to farthest edge of float ,holding carb vertical
...float chamber gasket is still on the carb, reduce the measurement by approximately 1mm. As a side note, I went to an auto parts store to buy a gauge to set mine - they didn't sell them ...
Question about Suzuki VL 1500 Intruder LC Motorcycles
carb kit i need the spec for float adjustement the gas comes out the over flow if the exact height is not known , a good rule of thumb , is to tilt the carb on its side (with float bowl off) and watch
Question about Suzuki VL 1500 Intruder LC Motorcycles
carb is positioned upside down) to the gasket surface of the float bowl as illustrated in the next picture. You can use an open-end wrench (sized per your spec), a small metric ruler, or a float level
...need carb rebuilding new needle seats and check the floats for leaks ( put them in water see if they sink. do a thorough carb cleaning job on them and you need to check specs for float level
Question about Suzuki VL 1500 Intruder LC Motorcycles
...CBX. I installed new float needles and seats. Also, I adjusted float levels to factory specs. All carbs are still flooding. I PRESUME YOU THOROUGLY CLEANED THE FLOAT NEEDLE SEAT?AND INSPECTED THE ...
...carb, the float level has to be set with the carb on an angle. To illustrate this, I'd have to send you a picture. I'd be glad to do so if you're contact me directly as this forum only allows a file ...
...carb body at a 45-degree angle to avoid compressing the spring in the fuel inlet needle. If you find that your measurement does not match your float level spec then you can carefully bend the float ...
Question about Suzuki VL 1500 Intruder LC Motorcycles
carb float and what are the specs you can adjust a float by taking the little pan off of it and just bending the stop that goes to the needle valve , usually you do not have to do this to carbs , what
229 questions posted
Usually answered in minutes!
131 Questions
71 Questions
40 Questions
22 Questions