2000 Suzuki GSX 600 F (Katana) "loose throttle cable" Questions

Ad

...if i open the throttle up the rpms rev high but doesnt go no where unless i let of the throttle thats when it picks up ? check clutch cable maybe loose enuf to work but not enuf to make good ...

Ad

Question about Suzuki GSX 600 F (Katana Motorcycles

2 Answers

...loose. Clean the throttle sleeve and handlebar off alcohol. Now, some people like to use "Grip Glue" on the new grips. Put the glue inside the grip and slide it up on the handlebar. If you put the ...

Ad

Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

...loose and slide the throttle sleeve off the handlebar. Now, lubricate the inside of the new throttle sleeve, the cable area of the throttle sleeve and the handlebar with fresh white lithium grease. ...

Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

...throttle cables after replacing handle bar. adjust the cables to were they are as loose as possible. one cable should be for snap back and the other for the actual throttle. you will have to put the ...

Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

...loose on the handle. When turning the throttle, there is a small click, but nothing happens. trace the cable to the connection on the motor.check that throttle lever is connected to cable,and lever ...

Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

...on suzuki rf 600 might be a kink in your throttle cable or its come loose from one of the ends that hold the cable in place and have too much cable has threaded out. or your throttle grip is

Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

...throttle cable adjusting nuts in fully to give throttle grip lots of play with throttle grip closed turn out the decel cable adjusting nut until the cable just becomes tight. tigten lock nuy. turn ...

loose. The throttle/ handle is loose. I can move it about one cm to the left and right. you need to replace or tighten the throttle hold down screw right just being held in place by throttle wire this

throttle gets extremely tight even with the cables completely loose as soon as I tighten down the housing...I can't figure it out and it&# I have. 93 Fatboy I put on Avon grips for some reason the

Question about Suzuki GSX 600 F (Katana Motorcycles

1 Answer

...going into the carb. The cable could've jumped out of the retainer if it was loose to begin with. Also I would check the throttle lock on the bottom of the housing. Make sure that is loose as

Not finding what you are looking for?
2000 Suzuki GSX 600 F (Katana) Logo

72 questions posted

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...