1993 Suzuki GSX 750 F (Katana) "fuel gauge keeps moving" Questions

fuel pet-****. Take out the carb assembly, remove float bowls. Remove air jet and main jet. Force air through every oriface. The face of the carb on the bottom of the air intake port is 2 little holes

...fuel gauge on the dash. To counter this, get yourself some plumbers tape, the very thin stuff, and wrap it round the metal bar where it goes through the potentiometer, the part that is most worn. The ...

...Fuel Screw located on the engine side, opp. air filters. In or out for air? Category section would not let me enter proper info. Those arent ajustment screws as the screws are in front of the float ...

...fuel gauge wires, the remove the tank bolt , then cross plate that is over the top of the frame. You can now move the tank to the rear and out of the frame. This is a long and tedious job that you ...

...fuel will come out anyway in this position and with it comnnect to the carb if it still doesn't run the problem can be in the carb. Before going into the carb you might check compression first. ...

...fuel pump turn on and when i hit the start button the light goes completely dim. the bike doesnt even spin over or nothing. could it be an ecu problem or maybe a kill switch or something???? hi had ...

...gauge. But still feels like it is going to stall out during stops. If I leave the lights on for 30 min or so, the new battery will run completely dead. Problem seems to be draining the battery too. ...

...gauge does not get up to 1/4 hardly. Will warm up in garage nicely after 20 minutes. It is plus 5 degrees celsius here the past few weeks. it is not biking weather for sure. I thought I'd tell you ...

...fuel treatment will clean the carburator, but not usually successful in cleaning the idle jet. Usually it requires removing the carburator bowl and and cleaning with the use of a gauge wire. The idle ...

...gauge fuel valve if it has one to allow fuel to reach the gauge. If the gauge has a relief valve and line open it slightly to bleed out any air in the line until no more air is visible. Catch the ...