Question about Suzuki DR 350 S Motorcycles
...compression release on each cylinder that activates when you press the starter button. The front cylinder release is directly attached to the solenoid. The rear cylinder release is opened by a cable ...
Question about Suzuki DR 350 S Motorcycles
2003 Suzuki Intruder 1500: What should compression be? I found around 121 for the front, stayed solid until I released the pressure, 135 for the back, stayed until I released the pressure. Question ...
compression release put in your heads I have an 03 FLSTC, same issue. Went through four starters before 70k miles. Problem solved when I had both the gear reduction and compression releases installed.
Question about Suzuki DR 350 S Motorcycles
...compression release operating properly? Is it stuck open a bit? Is the head gasket blown? Normal compression is 125psi to 150psi. This sounds like a stuck compression release, blown head gasket or ...
Question about Suzuki DR 350 S Motorcycles
...compression release. If so I need schematic for it along with procedures. im hoping its not a valvetrain problem. There is no noise wich makes me think it would be in the valvetrain. There is nothing ...
...is at TDC, you will know because it will be hard to kick, then pull the compression release down and as you start to kick release the compression release. NOT an easy task starting a 426 but good ...
Question about Suzuki DR 350 S Motorcycles
compression release lever have some free play? hi mate your rings are worn out replace them asap the compression is passing the rings even though there may be lots of compression still the compression
...and is their a way that you start these bike's with the compression release? thank's buy some 'start ya barstard' or aero start and spray directly in to the carby and start it just gives it a bit ...
Question about Suzuki DR 350 S Motorcycles
...sweat alot it starts and runs great. But if I try and start it again it won't start! Any tips? Its a Dr get used to it, just master the compression release and keep your carb and spark plug ...
I own a honda cb trigger bike. I m facing a problem of loss of engine compression after releasing throttle. After releasing throttle engine rpm didn't go down as quickly as earlier. It took some time ...
15 questions posted
Usually answered in minutes!
31 Questions
19 Questions
10 Questions