Question about Suzuki DR 350 S Motorcycles
...oil not to flow properly or you have a bad oil pump.check all hoses if it continues then take the cover off the oil tank , remove spark plug then hand crank the engine over and watch for oil
...issue with my 92 DR 350N. After lubing everything to the point of excess, I pulled the crank case cover and it turned out that there was a tooth on the chutch release shaft was broken. It's the ...
Question about Suzuki DR 350 S Motorcycles
how to remove seat to access the battery and carb. the throttle will not turn .is the bell/slide stuck? I just got this bike,7200 miles I think it has been in storage 2 to 3 years... Are there any ...
Question about Suzuki DR 350 S Motorcycles
... THE ONLY TIP I WOULD GIVE YOU IS CLEANLYNESS IS INPERATIVE, CLEAN THE MATING SURFACE OF THE ROCKER COVER AND CYLINDERHEAD, USE A GOOD SEALENT , IE HAELOMAR OR SIMILAR BUT DONT USE SILICONE AS THIS ...
took side cover off to replace gasket. the gears fell out so we stuck them back were we thought they would go now hard too start AND WHEN STARTS HEADER PIPE GETS RED HOTT wat should we do? I would be ...
...I want to be sure i'm not over looking any thing. the pump should be accessible through the RHS cover, if the pump is not working it may have worn out the drive gear, oil pumps themselves are ...
a lower bolt on the primary cover broke,so i removed the shifter and foot peg bracket,then removed all of the bolts from primary cover after draining primary fluid. The primary cover still doesnt seem
oil leeking from cover on right side oil leaking from cover on right side, not the cover with the looking glass, what is it called? where can i find it? Clutch plate cover? Dealer for seals unless the
I have a 1996 fxdl I changed the primary cover changing both primary gasket and inspection cover gasket. I now leaks around the inspection cover bolts . What are my options If you'll remove your ...
zx-9r 2000 how do you remove the clutch side cover to change the clutches Hello, The clutch cover is removed in a two step process. Remove the clutch cable by loosening the adjustment at top and ...
68 questions posted
Usually answered in minutes!
19 Questions
10 Questions
7 Questions