...stuck float needle that is allowing fuel to drain into the chamber and run down past the piston. The best way to remedy this is to remove the carb and clean it thoroughly. This will also happen if it ...
...stuck. The only solution is to remove the carbs and repair or replace the float valve mechanism. And, yes, the gas tank must come off. It is the only way to have easy access to the carbs. I did this ...
...stuck. Will getting fresh gas and or adding an additive help unstick the floats? Then I could get it to a shop anyway. the floats are easy to fix...getting to them is the problem. the old gass has ...
Question about kawasaki KLX 125 Motorcycles
...gas off while in riding, it picks up power then dies. is the float stuck? Either the float is stuck or needle/seat need to be replaced, or there isn't a strong enough or hot enough spark to burn the ...
...stuck in the float bowl valve or similar. You will need to shut off of the gas, drop the float bowl, check that the float move and closes the valve. If everything looks good and the valve actually ...
...stuck open because of some dirt under it.Remove the carb and pull the float bowl off and you will see what I mean.Sometimes you have to replace the needle valve since they do wear out and cause this ...
...6 months old & has float needle stuck. Clean carbs. & always replace the float needle valve assy's & bowl gaskets. There is nothing you can put in the gas tank to clean carb
gas on it all leaks out from the float bowl. the float is not stuck i checked it and replaced the O-ring on it, but it continues to just leak all the gas out. it's like the gas isn't even reaching the
...stuck in the down position flooding the cylinder with gas. Start by removing the carburetors and giving them a thorough cleaning . Closely inspect the sides and tips of the float needles.If they show ...
Question about kawasaki KLX 125 Motorcycles
...gas stuck flote? Float is stuck, or trash in needle valve. Pull carb clean it out, inspect the float, if you have any doubt that it is good then replace it, and reinstall, should clear up the ...
56 questions posted
Usually answered in minutes!
22 Questions
17 Questions
1 Questions
1 Questions
