2003 kawasaki KX 125 "reeds replace" Questions

... The reed valve assembly should hold solvent withot leaking. Remove for test. Disassemble and clean reeds and reed seat. Perfect seal is very important. Good luck, Techjoel the best way to tell is ...

...reeds.If you have done a rebuild because something internally has destroyed itself then the chances of those loose metal fragments chipping or cracking a reed are quite high.Pull the reed block and ...

kx 125 1992 wont start was going great just stopped,can kickstart all day will not go just makes a puff noise,please help wont 2 ride again ,cheers tankman1 sounds like the rings are fried and needs a

my 2003 KX 125 will not start. Replaced all jetting down one size mixture was to rich 400 main, 35 pilot, needle pistion 2. Also clean the carb found no problems with build up or reed damage. Check ...

...and reeds just bolts in (4 bolts) I sell them for about $160 delivered, or if your know what you are doing then you can just replace the reed petals with new... About $60 ...

Changing my reed valve( KX250) What do I have to remove in order to replace my reed valve, take of your carb the reed valves is at the back of that rubber moulding

...replaced, new plug with good spark, fuel seems to flood back into carb rather than getting through reeds. Any ideas what could be the cause. Cheers Colin Sounds like you have very little

I have a sxr 800 stand up jet ski. It no longer has good bottom end power and it feels like it is hitting the rev limiter on the top end. I replaced the exaust pipe orings so there is no exaust ...

...the inlet manifold that holds the carb,remove the reed valve block and check the condition of the reeds(if you can see daylight through the valve seat)ie between the reed valve and the base ...

over fueling front cylinder RGV 89 have since replaced reeds with carbon type and leaned out droping the needle on the carb by one slot any ideas guys ? Sometimes changing to carbon reeds is a bad ...