Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...put new in . where is the bleeder located. remove the old fluid from resevuar with a small hose, refill with new, and bleed out the old that is still in the line.keep an eye on the level as you bleed ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
want build pressure put on a new slave cylinder.no leaks anywhere. THIS SYSTEM WILL NEED BLEEDING AS WOULD A BRAKE SYSTEM USING BRAKE FLUID. THERE IS A BLEEDER SCREW DOWN AT THE SLAVE FOR THIS PURPOSE
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...new fuild and spit it out. Next top off the reservoir near the clutch handle. Seal the lid tight. Put the bike back on it's kick stand. Next do this about 10 times. 1. open bleers. pump clutch. close ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...and the brakes were fading.He wasn't sure if they put any new parts on the bike or just flushed the system.Main thing was though,after the bike got hot,the clutch faded to nothing.I hope this helps ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
... bad like!!! the problem is,, you need a new cluch fitted to the bike which is far from cheep to get repaired,,,,,and its a big job too, i hope this has put you right,, good luck,,from1 biker 2 ...
...put a new battery in it changed the gas and oil and got it running and everything is fine but the hydralic clutch has no pressure and when you put it in gear it stalls out. It has no manual with it ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...new o-rings for the clutch slave cylinder . Then you should get enough pressure in the system to operate the clutch. Often a wet clutch that has sat for years will have the plates stuck together. One ...
...put in gear it dies is there a way to ajust it ? Fill your clutch fluid reservoir with DOT3/4 brake fluid and bleed the hydraulic clutch system. If it will not stay bled and there are no leaks, take ...
put in gear. the bike has 75k and runs like new, the discs looks like new . i cannot see what part on the clutch assembly will create pressure inside the basket setup. any help is appreciated, Hey End
...put it on centerstand and it shifts gears just fine. is it my slave cylinder as i know my master is good and i have bled lines have very good pressure at handle but cant downshift. please help. ...
67 questions posted
Usually answered in minutes!
175 Questions
86 Questions
60 Questions
52 Questions
44 Questions