2001 kawasaki VN 1500 Vulcan Classic "starting fluid work fuel injected" Questions

fluid into the back of the inlets, then attempt to start it.   If it attempts to start the fuel system needs cleaning, fuel pump isn't working, regulator issues, fuel injectors bad.

...fuel pump not operating. No power to pump. Pump relay tests ok with meter check. sprayed stating fluid in throttle body. It kicks and tries with fluid or gas. Security light on dash. many various ...

...starting fluid on the intake manifold where it bolts to the heads with the engine running and fully warm. If the RPMs either increase or decrease then you have an intake leak. It could also be that ...

...make sure the battery is fully charged. Then check the air filter. Try starting it using a squirt of starter fluid shot directly into the air chamber. To do this, remove the air filter

...fuel change your engine oil & filter remove & clean air filter replace element if it is beyond cleaning lubricate & adjust your chain lubricate all cables check wear on brake pads & ...

...IF THAT DOES NOT WORK TRY REMOVING INJECTERS AND SOAK THEM IN THE SAME NEAT FLUID. ALSO HAVE YOU CHECKED THE ELECTRICS TO THE INJECTERS AND ALSO THAT THE PLUGS ARE CLEAN AND SPARK UNDER

starting fluid sprayed to intake Sounds like you're not getting fuel for some reason. If your bike is equipped with a carburetor, the fuel petcock may not be opening properly. In 1996, Harley went

...starting fluid at seals if there is a change in idle change seals, with air filter off cycle ignition 5 or 6 times and watch to see if the injectors are leaking. After that open throttle plate and ...