2001 kawasaki ZX-6R Ninja "brake pad" Questions

Ad

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

what brake pads etc and disks do i need for my bike. ZX6R Ninja (1996) (P). These are the part numbers from Kawasaki Front brake pads, you will need 2 sets 43082-1142 The front rotors have been ...

Ad

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

...brake pad's retaining pin on the outside face of the caliper using a pair of needle-nose pliers. Push the retaining pin out of the back of the caliper with your finger. 4 Pull the brake pads and ...

Ad

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

help replacing brake pads pads are simple enough maintenance should be only 2 nuts holding on each caliper take of the caliper cant go wrong there when off have a look at the nuts and bolts holding ...

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

...some times these spacers are diffrent sizes ,so remember there position ) .You need to remove the brake cylinder .But you may find that the brake cylinder unit will not clear the brake disc because ...

...brake pad cover...it will pop off. Remove the hairpin type clips off of the ends of the brake pad pins.... Use pliers & pull the brake pad pins out from the front of the rear brake ...

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

...brake pad using the same orientation as the pad previously removed. Curved portion of pad must face upward. Install pad pins until the pins snap into place with an audible click. Do not fully tighten ...

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

...pad spring. Remove the brake pads. Install new brake pads into the caliper so thier ends rest into the pad retainer on the bracket properly. Install the pad pin by pushing in the pads against the pad ...

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

brake pad set. Install the pad with two tabs on the inboard side of the rear caliper. Fifthly install the new inside brake pad using the same orientation as the pad previously removed (with the curved

Question about Harley Davidson Motorcycles

1 Answer

brake pad set. Install the pad with two tabs on the inboard side of the rear caliper. Fifthly install the new inside brake pad using the same orientation as the pad previously removed (with the curved

Question about kawasaki ZX-6R Ninja Motorcycles

1 Answer

...brake pad relacement rear caliper The minimum brake disc thickness is stamped on the side of the disc. Maximum brake disc lateral runout or warpage is 0.008 inch (0.2 mm) when measured near the ...

Not finding what you are looking for?
2001 kawasaki ZX-6R Ninja Logo

216 questions posted

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...