1999 kawasaki ZX-6R Ninja "rpm" Questions

my bike jerks at 6 to 7000 rpm when i drive it if my bike is standing it revs very good, when i drive it it jerks from 6 to 7000 rpm. if i pull the clutch and revs over 7000 rpm it runs beautiful. ...

Poor performance at low & high RPM Hi, my ZX600F 1996 is having a strange baveour through its whole register. From approx. 2000-5000 rpm. is it stalling as it gets too much fuel. From approx. 5000

AT 6000 TO 7000 RPM BIKE DONT PULL IF I RIDE MY BIKE, AT 6000 TO 7000 RPM THE BIKE DONT WANT TO PULL. IF IT STANDS STILL IT REFS UP Hi and welcome to FixYa, Offhand, I would suspect an airleak on the ...

...system should put out at least 6 amps of DC current, measured at the battery, at roughly 4,000 RPM. You can also do a quick and dirty check with a regular volt meter by reading the battery ...

...On the otherhand, refusing to accelerate past a certain speed (or more particularly, a certain RPM while under load) indicates an air leak. Test drive the bike again and note where it starts to ...

take the bike to about 9000 rpm and it starts to back fire zx6r g2 at those revs the valves are probably starting to float, something to look into,i may be wrong

pilot jet bike will only idle down to about 5000 rpm no matter where I set the p jets,why? Either your throttle cable is stuck, or the idle screw is turned up too far.

...Set the meter on direct current and test voltage directly at the battery. With engine at 3500 RPM it should charging at least 13.6 volts. I hope this

...working zx 6r ninja when you put ignition on will not do full sweep and nothing is working no rpm or mileage or Speedo Better get the full info from the oem manual. Try tradebit or ...

I have Kaw 600 ninja.It starts and runs greats up to about 5000-6000 rpm,then starts missing.The thing almost gos dead.What do you think is wrong? sounds like fuel starvation, have you checked the ...