need to pull in the clutch leaver to start? Make sure engine kill switch is in run position, Make sure you have petrol if more than 2 months old change it. Check main and ignition fuses are OK in fact
Question about kawasaki ZX-6R Ninja Motorcycles
...need to change the rectifier? or is there another likely solution? you will need a volt meter across the battery, it should read around 12v with the engine stopped and rise to around 13-14v with the ...
...motor cut out at the same time. Coasted to a stop and stated up again and slowly went home ... has anyone have any thoughts as to why this happened. Oil does need changing , ST1100 ...
...change the bulb, if its not the bulb, check you have power to it from the live+ wire if you have check the switch, to check the switch disconnect the the two wirers at the plug and put a piece of ...
Question about Suzuki Motorcycles
...stop to the drain migrates to different areas for example : it could be stopped by unplugging the head light or switching to high beam, or pulling the headlight fuse ..... but then one by one ...
...light relay ,not sure where it is at....more extensive problem ??? the dealer sells service the manual with all the wireing diadrams and locations of the components all u need to fix any thing on u ...
Question about kawasaki ZX-6R Ninja Motorcycles
...need the wiring order at the tail light socket to wire running and stop nlight on a 2009 street bob H-D I don't have a schematic for a bike this new but usually Harley uses a red wire for the stop ...
119 questions posted
Usually answered in minutes!
157 Questions
84 Questions
79 Questions
51 Questions
51 Questions