1998 kawasaki KLX 300 "valve timing marks need know" Questions

valve cover off on top of the enging Tanks in advance Kind Regards the cam timing marks are on the cams and the rocker cover has to come off to see them. Honda usually leaves enough room for cam cover

Valve timing is done with the piston at Top Dead Center. The cam lobes should be pointing downward. There will be a mark or marks on the cam gear for alignment of the gear. If only one mark, it should

to change it. Valve timing is a different matter and involves static timing marks on the OHC gear. If the bike runs at all then the valve timing is set properly as is. Pleas rate this solution. Thanks

need to know ignition timing on a1945 wdco 350 royal enfield 5,16 btdc more or less Just replaced mag TDC should put piston 1 to its highest position with valves closed (compression). 5.16 BTDC if you

...timing marks are lined up. model is not listed ; 125T-9A 50cc at present time. When your piston is at top dead center - and you roll the crank shaft in the forward direction - the next valve that ...

valve clearance while you're there - on the bear trackers a little older - the lever for forward or reverse - the large screw facing the back of the bike of the three - take that out - and you can see

...torn down and rebuilt from bottom to top and we have yet to be able to find the right timing settings... Anyone have this problem or know how to handle the problem the valve clearance may be too ...