Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...water pump but doubt it sounds like head gasket was it installed correctly? the head gasket is a crush gasket and can only be tightened one time after that it is junk and will not seal again there ...
...with all the gaskets and seals necessary to remove the lower front cover and replace the water pump (K&L makes the kit ($25)). You do have to take off the lower front cover to replace the
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
replace the water-pump together with new gasket. 1. Drain the coolant into a container by opening the radiator cap, and the drain-plug under it. 2. Remove the water-pump hose and the bolts . 3. Put in
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...tighten things back up. Inspect the water pump shaft and replace it if it is worn or grooved where the seals ride on it. Don't forget to get a water pump gasket and a right crankcase cover
...replace the water pump shaft if it is scored. Chaz- Moto DC Milky oil generally means the oil has been contaminated with water. Drain the oilpan and flush it with kerosene, and replace it with clean ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...water pump. Is the problem likely to be some sort of seal needing replacing or something bigger? If it is leaking directly under the water pump then the water pump stem seal is bad and the water pump ...
...actually need to replace the water pump assembly. To see a break down of the pump look here. ...
Question about kawasaki VN 1500 Vulcan Classic Motorcycles
...away from the engine, replace the pump using a smear of oil on the pump oring tighten the pump bolts evenly replace the water pipes and refresh the coolant, checking the level again after cooling ...
water pump in the little hole under the water pump evrything is new for the water pump so how can i stop the pump from leaking.? Some water pumps are considered replacement items and are no repairable
replace do i have to remove the head please help thanks Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1
124 questions posted
Usually answered in minutes!
175 Questions
86 Questions
52 Questions
44 Questions
41 Questions