1997 kawasaki ZX-6R Ninja "check magneto voltage" Questions

...Check magneto wheel contacts for contaminants, like oil buildup or rust ( contacts are slightly raised from magneto inside surface). If oil, use spray with an old tooth brush to scrub off the oil. If ...

...check your "charging system" not a magneto! on these bikes you have a Stator that is in the LH side cover on that engine and you need to check the windings for continuity and for short to ground. I ...

...Voltage Is Checked With Engine Running. Always Perform This Test At Cranking Speed (R.P.M.) For SAFETY. 120 Volts (AC) Can Be Present With Engine Running. REplace coil MOPAR KENNY I have the same ...

...The magneto likely puts out AC voltage(check with a multi meter) It has to charge the battery through a regulator, which has diodes to convert to DC and stops it discharging though the mag ...

...magneto through a light switch (if you don't have a battery, ignore the light switch). The output side of the light switch is a Red wire. This Red wire feeds both the taillight and a headlight. The ...

...magneto check for current and compare to man. specs.  it could be your point spacing or even magneto itself,  if it is "mag" buy an aftermarket light kit it should come with mag, and all ...

...magneto trigger, and the voltage and ohms are okay. I’m stuck. I have the service manual heres a service manuhttps://www.motorcyclemanuals.info/motocycles-atvs/arctic-cat/al to down load

...check the voltage coming from the alternator (magneto). Make sure all the wires in the harness are connected properly and none of them are broken. Hi, Please check the voltage output of your ...

magneto or stater battery drains while riding well take volt meter charg battery fist start bike but volt meter on pos and neg see if you have 13.5 volts or moore if you dont then i would check ...

battery goes flat within a few days of no use Check the voltage regulator. I'm not sure where it is on your bike but it should be near either the battery or magneto.