1996 kawasaki ZX-6R Ninja "bike fire three cylinder" Questions

...fire on 1&2 Hello i have a 01 gsxr 750 and it does not seem to be firing on # 1&2 cylinders but fires on three and four and as i raise the rpms nuber two seems to come back to life but not ...

...bike has an after market single fire ignition system, the ignition system could be bad causing the missfire. In this case, you would have an aftermarket coil as well with three primary connections on ...

...of cyl numbers on the motor The right front cylinder when you are sitting on the bike is the number one cylinder. Left front is number two, right rear is number three, and left rear is number

...fire but will not run once you let go of the starter. Low milage only about 16000 I want to purchase this bike but I want to hear it run this is a Canadian bike so it is a 750 X there is a n air mix ...

...bike is equipped with a single fire ignition. Your use of the term "top winding" indicates that there is a "bottom winding" or two windings on the coil. A single fire coil will have three small ...

...bike runs and getting fire to all cyclinders bike has new plugs I think carb problem plese help hi,that doesnt sound like a lot of fun,i dont think that all three carbs would have failed at the same ...

...three years, gas was treated. I tried to start after putting in new battery and it fired right up, but its popping? Engine was running perfect 3 years ago when I stored bike. It fired up right away ...

...three cylinders engine lacks power change spark plugs and possibly ht leads Has the bike been in storage? The 2000 still had carbs which tend to gum up after sitting for a while. You could try a good ...

...bike. Had been sitting for three years but shows only 9,800 miles. All electricals work. Installed new battery, new plugs, bled carb bowls (fuel was nasty), cleaned fuel tank, and added fresh gas. ...

bike. Firing order does not really apply to these motors as the coils fire twice per cyl. The left coil will fire 1 & 4 the right coil will fire 2 & 3. I usually hook them up as follows: Left outer to