Question about Road Motorcycles
...clutch release rod on fl To replace the clutch release rod on a 2001 Harley Davidson Road King FLHRC1 motorcycle, follow these steps: Shift the motorcycle into first gear and place it on a lift or ...
Question about kawasaki ZZR 600 Motorcycles
...clutch release inside. Make sure the outer drum cover is tight--check with the clutch lever to make sure the plate releases the disks and plates. I doubt the problems are related. New fiber friction ...
...clutch release shaft #13102. The end of the shaft may be broken, bent or severely worn. The part the shaft engages with is the clutch rod #46102. It could be bent, broken or severely worn. This part ...
...clutch release arm I believe the arm is on top of the case on the left hand side attached to a shaft that goes into the case. It also may have a bolt in the side of the case below the arm that has a ...
...clutch release oil seal on a suzuki gz250? Also, am I in way over my head? Is this something that can be done without taking the whole engine apart? I think it can be, according to the book. i just ...
Question about kawasaki ZZR 600 Motorcycles
...clutch cable length (inner cable vs outer cable), broken shaft, bent then broken shift fork stems, broken slider gear dogs and a missing shift fork pin. You didn't say if anyone had worked on the ...
clutch release camshaft seem to give up and there is no pressure at the handle again. i have adjusted the clutch pushrod, i have went through the clutch assembly multiple times to see if they were out
Question about kawasaki ZZR 600 Motorcycles
...clutch release shaft on a KX 125? I have a 2003 KX 125 and I was replacing the clutch cable when the clutch release shaft came out slightly and would not go back in place. I am wondering what I have ...
...clutch release arm is knirled and attached to the shift release shaft that is extending into the case cover. There should be a 3/8 or 7/16 bolt tapped into the side of the arm. The thread extension ...
Question about kawasaki ZZR 600 Motorcycles
...CLUTCH NOT RELEASE!! HAD A NEW ONE PUT ON AND WAS FINE FOR A DAY OR 2 AND DID THEY SAMETHING AGAIN!! SO WHAT CAN CAUSE IT TO KEEP BURNING UP ACTIONATOR IN THE CLUTCH The only thing that COULD happen ...
49 questions posted
Usually answered in minutes!
35 Questions
23 Questions
21 Questions
22 Questions
13 Questions