...resistance on secondary side and make sure all earths ARE earthed.....First of all i'd check the pulse/trigger coil , it could be completely dead.that would be the black/yellow and green/white wires ...
at cold they close again so hard to diagnose as resistance reading will be fine when cold. About 45 GBP for a genuine triumph one. About an hours work to fit it inside right hand crank shaft end cover
...resistance. is there a shear pin/key? Check for loose compensating sprocket. Any strange noises when cranking? Most unlikely but could be loose/sheared half-shaft on crankshaft. Also damaged splines ...
...crank, pistons, cams) or main shaft in the transmission. At this point, I suggest taking out both spark plugs, removing the PLUG, STRAIGHT SCREW from the left side of the crankcase, then put a socket ...
...shaft or an idler gear that rides on it or both. Either or there is likely metal bits loose inside the engine. Pull the spark plug and with the ignition off work the kickstart through it's paces and ...
...crank shaft and pops off, (don't use gear puller or dent puller or pound on flywheel with hammer). Three bolts hold starter clutch to flywheel if bolts are broken or stretched, they are 8mm X 1.25 ...
Question about Yamaha Motorcycles
...crank shaft seals, worn rings if 4 stroke it will occur when the inlet valve is open this can be from incorrect valve clearance opening the valve too early the ignition can be from a loose earth wire ...
7 questions posted
Usually answered in minutes!
7 Questions
6 Questions
7 Questions
6 Questions
5 Questions