Question about Honda CBR 600 F(4)i Motorcycles
...wire or split pin turn the igntion switch on and count the blinks one long one means ten recored the the blinks and phone a dealer and ask them for the fault code.to reset the the light pull out the ...
...kill switch, verify that the green wire to the CDI does not measure 0 ohms to ground; if it does, check the ignition switch and the engine kill switch; it it measures anywhere between 50 ~ 500 ohms, ...
...kill button from the CDI box. Disconnect this wire before it gets to the ignition switch and kill button, then check for spark. The most likely cause is a broken kill switch on the handlebar, or ...
Question about Honda CBR 600 F(4)i Motorcycles
...wire goes where. one comes from the kill switch and the other comes from the cdi unit. they both have hoops on the end. which end of the coil do they go ? Connect the the + to the kill switch, and - ...
Question about Motorcycles
...physically look to see which wire on bike goes to ht coil, the kill switch, 2 from magneto and earth or to from earth. hope it helps ...
...wire either at the emergency stop switch (kill/run), ignition switch or preferably at the CDI connector. Additionally, you can try: start with the side stand up; check/wiggle the 6 wires coming from ...
Question about Honda CBR 600 F(4)i Motorcycles
...kill switch is in the run position) -removed other fuses for lights etc -changed plug wiring (caused backfiring so I know it's correct now) I'm at a loss as to what could possibly be wrong. (My bike ...
kill switches including the side stand switch, with an Ohmmeter. How good is the battery? Check the fuses. Check the wiring harness. Are all wires clean and with a solid connection? Any abraded wires?
...kill switch wire? and does it need to go to the CDi unit? Is there anything else I should know? Thanks for your help. Chris could be black or green,but if it is disconected it sdhould run as the ...
...stator and just plugging it in,after two weeks a new cdi and coil i noticed there were two wires transposed. Unplug your kill switch. Then if it works, swap the wires to the kill switch and try
85 questions posted
Usually answered in minutes!
20 Questions
24 Questions
12 Questions