Question about Honda CBR 600 F(4)i Motorcycles
...gear grinding noise was deafening and chain seams to kick. now ordered new chain and sprockets , but is there something else what it could be. thanks alan No.That was the problem.The chain and the ...
Question about Honda CBR 600 F(4)i Motorcycles
...gear the back wheel is locked BOTH ways (but free spinning in neutral). Tranny is OK, valve cover off shows cam chain ok. Did starter motor go? How to get access to starter drive? Can I take starter ...
chain is slipping on the sprocket sometimes when in gear with the clutch pulled the back wheel is still turning when in gear sometimes it does not want to go into neutral as you see it is not all ways
...gear... and the bottom of the chain kicked and oscillated a little bit too much.. approx 2-3 cm. Now if I raise the throttle slowly the chain does not kick, but on releasing it it does so again. This ...
Question about Honda CBR 600 F(4)i Motorcycles
...chain ok .engin dont turn .in back off the motor noise chaine turn in empty... If your starter motor is running and the engine is not turning over, then the problem is in the one way clutch attached ...
...chain off, if the wheel is still stuck, it could be wheel bearings, If it turns freely, I would say your transmission or primary gears have locked up.. Also, check and make sure the rear brake has ...
...its the chain &/or sprockets)Broken tooth on a gear in the gearbox. I hope not as again a more difficult & expensive repair.Hope this helps you narrow down your problem Regards Andrew ...
...gear for chain on motor sprocket.Replace it if worn to that point. Hi,it dose sound like the front sproket has got worn teeth,but by tacking the wheel back to take up the slack when the sproket is ...
Question about Honda CBR 600 F(4)i Motorcycles
chain about 1-1.5 inch play in the bottom middle, (between wheel sprocket and output sprocket-on the gear box). Do this is small increments, 1/2 turn at a time, then measure. Re-tighten the main bolt,
...chain has not broken your one way clutch inside the motor is slipping. On the back side flywheel is a one way clutch that grabs the starter gear when the starter motor spins. It is designed to let go ...
85 questions posted
Usually answered in minutes!
20 Questions
24 Questions
12 Questions