1991 Honda NT 400 "remove back wheel lead" Questions

how do I remove the back wheel Take wheel nuts off 5...undo Exhaust bolts 2.....let air out of tyre and slide off while pulling exhaust over

back wheel off the ground, remove the 2 bolts securing it at the bottom, push it up to release it as it clips over a locating tab Disconnect the voltage regulator lead from the silver post on the main

...remove plugs from cylinders, load the HT leads with removed plugs, rest against engine and engage top gear. Press the starter and rotate back wheel slightly backwards ( rocking motion ) going ...

...back on and washed the bike.All it does is click when i push the start butten.Battery is fully charged and has shown no signs of going flat,the bike was going and starting fine till that. Probably an ...

remove cable at front wheel spindle, pull out metal square, see if its snapped. I think it's electrical. Take the Fairing offand ensure all the wires leading to the Speedo are connected and not loose.

...back on. I Need help, please advise. I'm going to give you a solution based on personal experience. I have a 1971 FLH, 1200cc. 16" front wheel, wide glide front end. One main breaker, for all power ...

remove tank, you should see radiator cap now... turn loose not off, just incase still has pressure... now follow lower radiator hose and it will lead to the water pump and on the water pump there is a

...remove the front wheel and take it to a shop and have it computer balanced. On a mag wheel, the lead weights simply stick on and are notorious for coming off after a while. Make sure the wheel is ...

...remove the pads, and chamfer the leading edge. By leading edge, I mean the part that the disc enters first. Imagine making a tape line from the center of the disc to the outside edge of it. If the ...

remove the bolt on the other side to drop the swingarm out Is it a through bolt? Does it spin on one end while turning the other? Put the nut back on and tap it with a lead hammer, see if it is just a