2003 Harley Davidson FLHRCI Road King Classic "gas tank gasket" Questions

...gas to keep it from shutting off . going down the highway about 70 mph bike run goods until i let up on throttle the the bike spits and sputtters for a few seconds then runs good up till i slow down ...

...gas tank. Normally the cap gasket never comes off, this time it diod and the wind blew just right where the gasket flew into the open gas tank. I thought the thing floated but it doesn't. I probably ...

...of the tank when the engine is hot it only does this with a half of tank of gas or more Check for pinched hoses for venting the tank. Also might be a faulty cap. Check for cracks in the gaskets,

...stick up into the tank a couple of inches (you might have to remove the tank from the bike to get it out) time to get dirty and have fun check tank venting,see if gas cap is properly venting the

...of the tank and the seams, ensure that the tank isn't rusting from the inside out. I had a V65 Sabre do that once - from previous owner improperly storing bike with only a tiny amount of gas in

...gas out of the bottom of #1 carb You are probably dealing with rust in the tank. Clean your tank, check your fuel petcock to make sure the filter , on the intake , is still there, maybe add an extra ...

...run from it,one to to carb/intake runner and one to what looks like a fuel pump? the fuel petcock diaphram might need to be repaled. or gasket that is from gas tank to fuel shutoff valve could be

...gas tank? The Speedmeter/Housing assembly is held onto to Fuel Tank by placing the rubber cushion on to the stand-off piece (Part of the Tank on top, welded on) and sliding the Speedo Assy over it ...

...it has been sitting for around three years, just today it began leaking gas from what we assume is the tank overflow tube PROFUSELY what is wrong? It could be from the gasket on your fuel tank

...gas from somewhere under my tank? My bike is sitting in a puddle of gas. What could be causing it to leak from somewhere under the tank? Well...A fuel line may have split due to heat, Or a bad clamp ...