2002 Harley Davidson FXDL Dyna Low Rider "remove front" Questions

...Remove the instrument console and the front and rear mounting bolts and then the instrument wiring and the overflow hose and the fuel line at shut off valve making sure the valve is "OFF" and drain ...

remove front tire on 2000 FXDL Jack up and support the bike with the front wheels off the ground. Yours might possibly be a different size but my 07' has a nut on the left side of the wheel that takes

...in that area. There are two bolts on the right side of the battery support. Loosen these two bolts and the battery will drop down a bit allowing you to remove the battery top cover and front

-". With key on check for 12v @ wire to "coil +" and "coil -" grounds through points. When ground's removed (points open) magnetic field collapses inducing high voltage (spark) in "secondary" circuit

...front half of the switch housing. The switch is held in by a couple of small screws. Remove the switch and unsolder the wires taking note of which wire goes where. Resolder the wires to a new switch ...

When using the front wheel brake the brake lihgt comes on and only goes off half way out. If released all the way out light stays on?????? I would guess that you have a bad front brake light switch. ...

...front end and is supported by the spring seat post in the rear. Most of the solo saddles were designed to bolt to the "T-bar". Simply remove the "buddy seat" and bolt on the solo. Now there are some ...

...front sprocket bolts are stuck. In this case, the small allen bolts needed a bit of heat to come undone. After the bolts are loose, it's time to break the chain. With the Terra-X chain tool, you ...

...seems that the bike has the wrong set installed. to short and too stiff, this is also a bit unsafe as you mentioned the bike looks a bit low in the front. remove legs and replace with proper