1971 Laverda 750 S "new carb installed runs choke" Questions

...new spark plugs, clean the air filter, clean or at least drain the carbs to remove any water in the float bowls. Do a compression check to see if the valves need to be re-seated. Not sure what ...

...new carb it is still having the same problem. after it warms up it runs grate. but when you first try to start it cold it dose not want to run at all unless I Hold my hand over the intake tube. The ...

...carb back into the intake using a new intake manifold seal. If you don't replace this seal, you may wind up with a vacuum leak and have running problems. Reinstall the fuel line and air cleaner ...

new one was installed. Remove the gas tank and check to see that the line is not being stretched anywhere along the way AND that the gas tank when re-installed is not stretching the line. The line may

...new points and condenser installed also. Dwell and timing set and timing advance checked. stabil gums up carbs drasin the gas and run a carb cleaner through that should fix the problem It could be a ...

...new battery today, want to get her going.Carb has thunder slide and needle kit installed 5+ yrs ago. No problems until end of last season. End of last season, ran with a little choke and contstant ...

new gaskets and loosely install the bolts. Once the carb is completed, install the carb seal on the intake and install the carb and bolt up the backing plate to the carb and the heads. This will align

...carb body. If you remove mixture screws , be sure you count the turns and write it down before you remove them so you can put them back in the same positions when you reassemble. Install new spark ...

Installed A Dynatec Ign. (Which Dynatec Assured Me Was OK To Use), Checked Valve Clearance, Synchronized Carbs. New Plugs, Whats Left? It could be jetted too rich,the choke could be engaging at WOT,or

...carb slides don't all move upward at exactly the same moment. If you haven't installed new spark plugs, do it. Soak the carbs in denatured alcohol after removing the slides and float bowls. Finish ...