Question about Kymco Xciting 500 Motorcycles
...//www.youtube.com/watch?v=qLlptrEQcRw i did not watch your video,however chatter noise on start up means lack of lube and cam end play so check for oil clearence between cam and bearing valve ...
valve clearences the bike wont start? re check make sure you had the engine on the correct stroke, remove spark plug, check piston is at tdc, and the cam lobes are facing down, recheck your clearences
...clearence between the valve and cam lobe on each valve, also recheck you have correctly fitted the spark plug caps on the correct plug. Recheck the fuel and vacume pipes are correctly fitted to fuel ...
...valve clearences you will have to remove the covers on top of the valves to gain access to the cam folowers, with the engine set at tdc using a feeler gauge check the clearence, the inlet should ...
Question about Kymco Xciting 500 Motorcycles
Valve clearence ' ,How to adjust it. "Valve Clearance" refers to the small gap between the valve lifter and the valve stem that allows the valve to completely close. Remove the Valve Cover and set the
need valve clearences for all valves... 0.0039-0.0059 inch 0.11-0.15mm inlet cold 0.0079-0.0098inch 0.2-0.25mm exhaust measure and record clearances before removing cams, then will need to get ...
...You need to adjust your decompression valve. You have to pull your tank off and your valve cover. The manual shows the cam position you need to be at to adjust the clearence. The clearence is ...
...valve clearence be on a 2003 kawasaki klx 400? Clearance should be 0.10mm-0.20mm (0.10mm-0.15mm for hot cams) same as the drz, intervals are supposed to be 14,000 miles but I used to do mine at less ...
Question about Kymco Xciting 500 Motorcycles
valve clearence specs as bike is not starting easy got hot cams maybe timing you should get the specs you need on google or phone honda tech
37 questions posted
Usually answered in minutes!
0 Questions
1 Questions
0 Questions