...start at 40 degrees, any help? your oil is to thick the same happend to my buell, it start and stall about 5 times befor it would stay running. around 45 degrees outside,I switched to a thinner ...
Question about Kymco Xciting 500 Motorcycles
Kymco Xciting 500 will run without problem for a couple of days and then stall for no reason. not sure how much gas is in it but buy yourself a bottle of gas line antifreeze and put a half bottle in ...
C3 STALLING ON BREAKING CAR STARTS AND RUNS FINE UNTIL WARM THEN STARTS TO STALL WHEN BREAKING. Stall as in cuts out ? Or no power stalling ? Have u got pipe from engine to break master cylinder are ...
Question about Motorcycles
REPLACED CLUTCH ON ZR 550 CLUTCH ENGAGES , BUT WHEN FULLY RELEASED BIKE JUDDERS THEN STALLS OUT . TRY TO ADJUST & GEARS WONT ENGAGE . bike stalls out when clutch is fully released , but wont adjust ...
Stalling Idle drops off after engine gets warm and the unit stalls. No warning lights glowing. Does it drop so low it stalls? How does the air filter look? How many miles on it?
Stalling out, when not completely upright Just changed the fuel filter, but bike keeps stalling when on the kick stand? Bike runs fine when upright, but as soon as it goes on a angle it stalls. My ...
Question about Kymco Xciting 500 Motorcycles
660 04 raptor hit puddle stalled me out wouldnt start after hit puddle started back fireing then stalled out no water in my air box got it running again and same thing just had stator and cdi box ...
2004 honda vtx 1300 c stalls out after down 2004 honda vtx 1300 c stalls out after down shifting. Have needed to keep choke slightly out to keep from stalling. What to do? Thanks. ever drain your ...
stalls when put in gear bike stalls when put in gear Does it yerk forward, if it does that it could mean that the clutch is not set correctly or it it does not release correctly Got a 1988 Nissan ...
Question about Kymco Xciting 500 Motorcycles
why dose my motorcycle stall when I put it in gear ? I have disconnected the side stand switch but still stalls. Just a guess, but sometimes when a load is applied to some motors, if they stall or bog
37 questions posted
Usually answered in minutes!
0 Questions
1 Questions
0 Questions