1989 kawasaki ZX 10 "drill wont screw screws" Questions

wont run right could you help There could be other things involved. Have you checked the tank and the fuel valve for crud. It should have a screen on the valve and it may have crud or rust stopping it

...drill in a small space, and it is possible to destroy a carburetor with poor technique. Good Luck! alot of newer bikes went with cheesy carbs they wont even have one it is factory set The screw ...

wont stay on without choke and bogs out when in half throtle Pull the carb, remove the float bowl and air and throttle screws then soak the carb in denatured alcohol for half an hour then clean it ...

...wont affect the actual carb tuning. It only lifts the slide up when you turn it in. Remove the carb from the intake and airbox rubbers and take off the slide cap. Drain the carb from all fuel. The ...

wont idle after its warm either.where can it **** air from-to need so much fuel?rubber tubes from air filter intacked and the ones to the heads are ok The stock pilot screw setting is one and one half

drill a small hole verry carefully through the aluminium cap  then pik it out with a screw driver  much safer way of doing it  (  whoever designed the cv carbs is both a genius and