...type) in the jack to verify that in fact there is dial tone there. Also make sure that the line cord is firmly plugged in at both ends until the latching tabs snap into place. Sometimes it's just a ...
...correct and what type of jack is that? It doesn't look like RJ 45 or RJ11??.. where to buy the cord or jack? That Jack is for a Direct Station Selection/ Busy Lamp Field ( DSS/BLF ) connection not to ...
...# 10, or # 200. 1.- With the phone on-hook, dial intercom, #, 652 (depending on the system type, the # may or may not apply) 2.- Enter the correct time using HH/MM/SS, like 07:24:00 3.- Press ...
Question about Panasonic Lands Phones
Type in your 4 digit password, the default one is "1 2 3 4". When you enter it in correctly, it will display "SYS-PGM NO?". This is where you can enter in the "number" associated with the task you are
...type in new name Prees bottom Arrow Button again, then Release button. go into prgramming, sets, enter your ext #, hit top right once, then bottom right scroll 3 times to set name, hit change on the ...
Question about BT Lands Phones
...USING THEINSTRUCTIONS ON LINE FOR THE BT ASPIRE The busy signal message only indicates that the phone doesn't get a dial tone signal. This could result from a problem with the wires inside or outside ...
...most of them. Changing the time on a Panasonic KX-TA624 system must be done from extension # 101 using a display phone. All others can use any display set. 1.- Press the "PROGRAM" button on the ...
...most of them. Changing the time on a Panasonic KX-TA624 system must be done from extension # 101 using a display phone. All others can use any display set. 1.- Press the "PROGRAM" button on the ...
...type phone. (You should have one of these on hand anyway, in case your power goes out. Without AC power, cordless phones won't work since their base unit would be off. The basic corded phone gets ...
Question about AT&T Lands Phones
correct wiring. If the problem is with your phone only, try to reset it. Take the batteries out of the handsets and unplug the power cord from the base and the wall outlet. Wait a few minutes and then
693 questions posted
Usually answered in minutes!
451 Questions
360 Questions
253 Questions
115 Questions
75 Questions