RCA 25403RE3 Corded Phone "error message check telephone line" Questions

...error message on a Vtech T1300 telephone can indicate that there is a problem with the telephone line or the telephone itself. Here are a few things you can try to troubleshoot the problem: Check the ...

...Error message says "Check Tel Line." I've (1) performed a hard reset (disconnected power cord, which helped once before); (2) checked to make sure plugs are connected at both ends (they are); (3) ...

...Check the message bank settings: Make sure that the message bank settings are correct and that the message bank is not full or locked. Check the phone's firmware: Make sure that the phone's firmware ...

Error message CHECK TEL LINE my phone line is connected and i followed all the right steps to connect my handset to the base HELP! This sort of issue requires you to check if the base or the phone ...

...message after power was restored after an outage. Obviously not working. Unfortunately, the E4 error is an internal hardware failure. You can try to reset the unit by unplugging the base station's ...

...message (alternate errors: fast busy signal or no dial tone), use your test phone at a different jack and determine if the issue persists. If you can, find where your phone service comes in and open ...

...message saying " Error: inhibited ". Would you plaese help fix my problem. Thanks for your support in advance. Tom Hansem Travel Tom, I had the "error: inhibited" problem with my RCA 4-line ...

...message at other jacks on both phones, find where the telephone service comes in. If you are lucky, that will terminate in RJ-11 jacks. Then open the service box and use your test phone there. If the ...

check to see what last occurred with the unit such as did the children play video games, did the electricity go out due to bad weather. You may see that there are many possibilities but let's focus on

...check out.this will clear which phone is crteating the problem.if still not get detected by disconnecting each phone 1 by 1 then its the switch settings problem.all the settings needs to be resetted ...