...impeller off of a AO Smith SQ1152 Pool Pump Motor? I removed the screw that attaches the impeller to the rotor but I can't get the impeller of the shaft.. i think they screw on and the screw ...
...AO Smith B230SE motor for pool pump. Old motor had left-hand screw that held impeller to shaft. New motor does not have an opening for screw. Will impeller be fine without screw? Did you try the ...
I HAVE A CENTURY POOL/JETTED TUB MOTOR. A.O. SMITH. I NEED TO REPLACE THE IMPELLER AND SHAFT SEAL. WHERE CAN I LOCATE THE PARTS FOR THIS MOTOR. 1HP parts can be found on amazon, take a look here: ...
ao smith 1.5 hp pool pump is leaking. A washer about an inch round popped off and is cracked and broken. I dismantled pump and took off the 4 long screws to get to the washer. At this point I'm trying
REMOVE IMPELLER FROM SHAFT A O SMITH PUMP MOTOR HIFLO HOW DO YOU REMOVE IMPELLER FROM SHAFT ON A A.O. SMITH CENTURY POOL PUMP 48FRAME HIFLO The impeller is threaded onto the motor shaft, take the back
How do you remove the impeller from the pump shaft on my USQ1102 pump? Tom Marchand Lock the end of the motor opposite the impeller and then turn the impeller off counter-clockwise.
...AO Smith on an FP5182-08 Flotec pump did not resume irrigation during manual switch over to another spray field. While checking it I found that the hum (attempt to start) apparently shut down by the ...
...ao smith ust 1152 pump? 1. Shut the power off. 2. Disassemble the pump case by unscrewing the bolts holding it. 3. Take the impeller (rotating element) off the shaft, as well as the impeller cover ...
AO Smith Model C48k2N143CIC. Can't figure out how to remove the motor from the plastic part that suctions the water in it. Take off the rear cover as to expose the capacitor. Remove capacitor. Place a
...AO Smith 2HP pump that I replaced today for my pool, the replacement went smooth, but when the new pump is started, it just makes a dry running noise but no water circulates. I've tested the ...
70 questions posted
Usually answered in minutes!