Question about Caterpillar Electrical Supplies
what cause the turbocharger to become red hot after running for few minutes The engine run on hydrocarbon, with magneto Hi Again: Check the exhaust system, muffler etc. to make sure that it is not ...
natural gas using a type C conversion kit. Generator ran fine the first few times I needed it. Lately, it been difficult to start. After priming it starts but stops. After several repeats is runs then
...and returns back to original state, then it is likely running lean. Check the gas regulator (this is LP or natural gas I am assuming since it is standby), the vent may be clogged on the bottom of
...Natural Gas, on NG it is not taking starting, showing CC1, then CC2, then CC3 then stopped. And in case if it start but in next few sec shows UU or Under RPM. Please help me how I can Slove it. It ...
Question about Northstar Electrical Supplies
...Natural gas version,I have 7" water column pressure at regulator. It will start ok,but then sputters to a stop. It has a keihin 22GA-SE12 carburetor.No one seems to know-help! I been using gen for ...
...natural gas. If it's cranking for a while and not starting, you should smell gas (not gasoline, gas like the gas grill before you light it). If not, then you have a fuel problem. In my case, all the ...
Question about Kohler Electrical Supplies
...natural gas generator and after starting, will run to high revs and then shut down, the code on the display is U U Any advise, my gas pressure in is 8"wc. Your gas pressure is too low and you may not ...
119 questions posted
Usually answered in minutes!
208 Questions
7 Questions
13 Questions
5 Questions
15 Questions