Question about McCulloch Electrical Supplies
...generator, as it is always turned on. If you use the ON/OFF switch it is stopping the prime mover. If you reset the AC breaker without load, and it stops - it means that you have short circuit after ...
WHEN I START THE GENERATOR I HAVE TO HOLD THE START SWITCH ON TO KEEP THE GENERATOR RUNING. The switch should be three positional. The upper position is only for starting. Continuous running is in the
How to fix a genset 6500 generators that stops when you turn starter switch loose? Check the oil level or any other alarm that can stop it. The switch may have lost its middle stable position and drop
Can it run for 7 days without stopping? Joe,If you ran your generator for 7 days, it would be running for 168 hours. You MUST stop the engine every 50 hours and replace the oil. Otherwise, you will ...
Question about Onan Electrical Supplies
onan marquis gold gas generator 5500 stops running after 5 minutes Check fuel pump pressure, how long has it sat. What load is on after it stops?
Question about Coleman Electrical Supplies
Generator dose not produce power,just stop working. While using a skill saw with the generator,the generator just stop producing power,clean brushes,check wireing still no power.Need help to solve ...
5500 generator stopped producing eletric after 5500 generator stopped producing electric after running for two hours brand new generator. motor runs fine First check with the dealer and see if it is ...
My diesel kipor 5kva generator wont shut by key , Caution the manufacture is recommending a cool down period of about 3 minutes to prevent overheating of the combustion chamber. the following is from ...
Question about Electrical Supplies
to hold the stop switch in the stop position for a few seconds until the gen. completely stops; is that normal ? Yes, perfectly normal. You need to hold the stop button until the generator has stopped
Question about Kohler Electrical Supplies
Have generator showing emergency stop code and will not start. Traced out emergency stop wires by manual and everything looked good. Tried to reset code. Original installer did not have 120 volts ran ...
119 questions posted
Usually answered in minutes!
208 Questions
7 Questions
13 Questions
5 Questions
15 Questions