Question about Onan Electrical Supplies
WHAT IS ERROR/FAULT CODE 37 ON A ONAN 5500 MARQUE GOLD GENERATOR ? Code 37 is a bad set configuration, that means engine cranking speed and generator output aren't happy with each other..
Question about Generac Electrical Supplies
...not starting due to cold to reset any shutdown code on units 2010 and newer, switch generator to 'off', press 'enter'. this will clear the code, then you can attempt to start by switching to
Question about Watts Electrical Supplies
...crank & code fault light blinks. I don't know what happened to cause this or how to fix it!! what model is it KY KV need that and Spec. If it blinks 3 times it indicates a lower service fault. While ...
Question about Onan Electrical Supplies
...Code 32 is a low cranking speed sense. You didn't mention a Spec # which would help. You say batteries are ok, but the generator is not getting enough cranking amps or voltage to maintain the control ...
Question about Generac Electrical Supplies
my standby generator is just cranking but wont turn all the way i have a guardian generac 20kw standby generator model 5506 which i bought from homedepot and installed about 5 months ago, It has been ...
...generator that sounds like it wants to start but will not. It has a service code of 36. I have changed the oil, air filter, and made sure there is gas getting to the carb. But it still does not want ...
...code residential generator Engine cranks, turns over briefly then shuts off and UU code appears. Checked oil: OK Suggestions? Could be the battery voltage. If your battery is not charging properly, ...
Question about Kohler Electrical Supplies
...generator the code oc comes When I try to start my kohler 12 res generator the code oc comes up. It will not turn over at all. I checked the battery and made sure it was putting out 12 volts. Checked ...
Question about Kohler Electrical Supplies
...code. If I reset auto switch by clicking off, then clicking run, then clicking auto it will start. Any thoughts on this issue? OC is Over Crank which generally means it cranked and cranked and failed ...
... I check propane flow, it is O.K., at least into the generator. I get my digital read but again not cranking over. You have to reset it because it locked out on on under frequency. Just pullout the ...
119 questions posted
Usually answered in minutes!
208 Questions
7 Questions
13 Questions
5 Questions
15 Questions